Table of Contents
Advertisement
SPEED CHANGE AND BELT ADJUSTMENT
Follow these procedures to change speed and
adjust the proper belt tension.
1. Disconnect machine from power source.
2. Open guard door.
4.Move the belt to the other groove (Fig. 3B)
5. Push handle bar (Fig. 3C) to get proper belt tension
6. Tighten the lock handle.(Fig. 3A)
7. Close guard door.
SPINDLE RAISING AND LOWERING: (FIG. 4. 5)
Procedures to adjust the main shaft in the up or
down position.
1. Hand wheel (A) must be loosened.
3. Hand wheel (A) must be tightened.
SPINDLE CHANGE
1-1/4" spindle assemblies are supplied with your
shaper. The assemblies are locked in a tapered seat
with a draw bar and nut.
CHANGING
ne wrench must be placed on the flats on top of
O
he spindle and the second wrench on the draw bar
nut (Fig. 6), this allows the spindle to
Turn the nut two times; tap gently upwards with a
wooden block, this will loosen the spindle from the
aper. Remove nut and lift out the spindle.
A
B
C
A
'
B
FIG.2
FIG.3
FIG.4
FIG.5
Advertisement
Table of Contents
