Advertisement
For cement wall, expansion bolts are required to fix
the camera. For wooden wall, self-tapping screws are
required.
5. Route the cables through the cable hole (optional), or
the side opening.
6. Align the camera with the back box/base plate, and
secure the camera with the back box/base plate.
Type III Camera
Figure 2. 11 Fix the Camera to the Ceiling
7. Connect the corresponding cables, such as power
cord, and video cable.
8. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below to get
an optimum angle.
Type III Camera
Tilt Position:
0° to 75°
Figure 2. 12 3-axis Adjustment
9. Fit the black liner back to the camera and tighten the
bubble of the dome camera to finish the installation.
Figure 2. 13 Finish the Installation
Pan Position:
0° to 355°
Rotation Position:
0° to 355°
Type IV Camera
Advertisement
