Advertisement
1). Loosen the No.1 adjusting screw to adjust the pan
position [0° to 360°].
2). Tighten the No.1 adjusting screw.
3). Loosen the No.2 adjusting screw to adjust the
tilting position [0° to 90°].
4). Tighten the No. 2 adjusting screw.
5). Loosen the No.3 adjusting screw to adjust the
rotation position [0° to 360°].
6). Tighten the No.3 adjusting screw.
2.3
Installation of Type II camera
Before you start:
Both wall mounting and ceiling mounting are suitable for
the turret camera. Ceiling mounting will be taken as an
example in this section. You can take the steps of ceiling
mounting as a reference when adopting wall mounting.
Steps:
1. Paste the drill template (supplied) to the place where
you want to fix the camera.
2. Drill the screw holes according to the drill template
and the cable hole (optional) in the ceiling.
Note:
Cable hole is required when adopting ceiling outlet to
route the cable.
3. Press the button to take out the main body.
Press
Figure 2. 5 Disassemble the Camera
4. Fix the mounting base on the ceiling with supplied
screws.
Figure 2. 3 3-Axis Adjustment
Figure 2. 4 Drill Template
Screw Hole
Cable Hole
Advertisement
