Table of Contents
Advertisement
Type D
Normal fuse
Blown fuse
■
After a fuse is replaced
●
When installing the lid, make sure
that the tab is installed securely.
●
If the lights do not turn on even
after the fuse has been replaced,
a bulb may need replacement.
●
If the replaced fuse blows again,
have the vehicle inspected by
your Toyota dealer.
■
If there is an overload in a cir-
cuit
The fuses are designed to blow, pro-
tecting the wiring harness from
damage.
■
When replacing light bulbs
Toyota recommends that you use
genuine Toyota products designed
for this vehicle.
Because certain bulbs are con-
nected to circuits designed to pre-
vent overload, non-genuine parts or
parts not designed for this vehicle
may be unusable.
Owners Manual_USA_M0C029_en
6-3. Do-it-yourself maintenance
WARNING
■
To prevent system break-
downs and vehicle fire
Observe the following precau-
tions.
Failure to do so may cause dam-
age to the vehicle, and possibly a
fire or injury.
●
Never use a fuse of a higher
amperage rating than that indi-
cated, or use any other object in
place of a fuse.
●
Always use a genuine Toyota
fuse or equivalent.
Never replace a fuse with a
wire, even as a temporary fix.
●
Do not modify the fuses or fuse
boxes.
NOTICE
■
Before replacing fuses
Have the cause of electrical over-
load determined and repaired by
your Toyota dealer as soon as
possible.
495
6
Advertisement
Table of Contents
