Table of Contents
Advertisement
122
3-2. Opening, closing and locking the doors and tailgate
bed by pressing the tabs and
pulling the protector.
5
Pull out the wire harness
from the vehicle bed.
6
Install the connector cover
(Type D, E, and F) to the wire
harness connector of the tail-
gate.
The shape of each connector dif-
fers. Install connector cover to the
corresponding connector.
Connector cover (Type D)
Connector cover (Type E)
Owners Manual_USA_M0C029_en
Connector cover (Type F)
Removing the tailgate
■
1
Open the tailgate to the angle
where you can release the
brackets on the support
cables from the lugs on both
sides.
Lift the support cable bracket
up and slide it off.
To unhook the support cable
bracket, keep pulling up the clip on
the bracket and unhook the
bracket.
Support cable bracket
Clip
2
Tilt the tailgate to about 45°
from vertical and pull up the
right side of the tailgate to
unhook the right side.
Advertisement
Table of Contents
