Toyota Tundra 2022 Owner's Manual page 137

Hide thumbs Also See for Tundra 2022:
Table of Contents

Advertisement

Press the "SET" button.
Press button "1" or "2".
Operate any of the seat adjust-
ment switches (only cancels seat
position recall).
Operate the tilt and telescopic
steering control switch (only can-
cels steering wheel position
recall).
Seat positions that can be
memorized (P.131)
The positions adjusted by the fol-
lowing procedure can be recorded:
Seat position adjustment
Seatback angle adjustment
Seat cushion (front) angle adjust-
ment
Vertical height adjustment
Operating the driving position
memory after turning the
engine switch off
Recorded seat positions can be
activated up to 180 seconds after
the driver's door is opened and
another 60 seconds after it is closed
again.
In order to correctly use the
driving position memory func-
tion
If a seat position is already in the
furthest possible position and the
seat is operated in the same direc-
tion, the recorded position may be
slightly different when it is recalled.
When recalling the driving posi-
tion
Take care when recalling the driving
position so that the head restraint
does not touch the ceiling.
When the recorded seat posi-
tion cannot be recalled
The seat position may not be
recalled in some situations when the
seat position is recorded in a certain
range. For details, contact your Toy-
ota dealer.
Owners Manual_USA_M0C029_en
3-3. Adjusting the seats
WARNING
Seat adjustment caution
Take care during seat adjustment
so that the seat does not strike
the rear passenger or squeeze
your body against the steering
wheel.
Registering/recall/cancel-
ing a driving position to
an electronic key (mem-
ory recall function)
Registering procedure
Record your driving position to
button "1" or "2" before perform-
ing the following:
Carry only the key you want to
register, and then close the
driver's door.
If 2 or more keys are in the vehi-
cle, the driving position cannot
be recorded properly.
1
Check that the shift lever is in
P.
2
Turn the engine switch to
ON.
3
Recall the driving position
that you want to record.
4
While pressing the recalled
button, press and hold the
door lock switch (either lock
or unlock) until the buzzer
sounds.
If the driving position could not be
registered, the buzzer sounds con-
tinuously for approximately 3 sec-
137
3

Advertisement

Table of Contents
loading

Table of Contents