Figure 14
1. Reel motor
2. Spline shaft
13. Mount a grass basket onto the basket hooks on the
suspension arm.
14. Repeat this procedure for the other cutting units.
15. Connect the cutting unit power
disconnect couplers; refer to
Cutting Unit Power Disconnect Couplers (page 23).
7
Adding Rear Weight
Parts needed for this procedure:
Weight kit, 121–6665 (purchase seperately) Note: not
1
required for units with the 3 wheel drive kit installed.
Procedure
This unit complies with the ANSI B71.4-2004 and EN
836 Standards when equipped with weight kit 119-7129
(2-wheel drive units) or 120-5750 (3-wheel drive units).
3. Cavity
4. Motor retaining bar
8
Installing EU Decals
Parts needed for this procedure:
1
Warning decal 117-9537
Procedure
If this machine will be used in the EU, affix the warning
decal 117-9537 over warning decal 117-9536.
19