Table of Contents
Advertisement
Operation
Remote Control
Your remote control has been programmed at the factory to operate with your garage door opener.
®
Up to 40 Security+ 2.0
remote controls can be programmed to the garage door opener. Older Raynor
remote controls are NOT compatible, see page 37 for compatible accessories. Programming can be
done through the door control or the learn button the garage door opener. To program additional
accessories refer to the instructions provided with the accessory or visit www.raynor.com. If your vehicle is
®
equipped with a Homelink
, you may require an external adapter depending on the make, model, and
year of your vehicle. Visit www.homelink.com for additional information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING THE
DOOR CONTROL
1. Press the navigation button below "MENU" to view the Features menu.
2. Use the navigation buttons to scroll to "PROGRAM".
3. Select "REMOTE" or "KEYPAD" to program from the program menu.
4. Remote Control: Press the button on the remote control that you wish to operate your garage
door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the
keyless entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been
programmed. Repeat the steps above for programming additional remote controls or keyless entry
devices. If programming is unsuccessful, program the remote using the learn button.
1
2
Press
4
3
to continue.
Press
to continue.
TO REMOTE
OR
?
?
?
?
PIN
PROGRAM USING THE LEARN BUTTON ON THE GARAGE DOOR OPENER
1. Locate the Learn button on the garage door opener. NOTE: Your garage door opener may
look different.
2. Locate the Program button on the remote control.
3. To enter programming mode, press the Program button until the LED on the front of the
remote control turns on.
4. Press and release the Learn button on the garage door opener. The Learn LED will light.
Within 30 seconds...
5. Press and release the remote control button you want to use...
Check to see if the garage door opener light bulb blinks. If not, wait for the remote control LED
to light solid then slowly press and release the remote control button again. Repeat until the
light bulb blinks.DO NOT press the button after the light bulb blinks.
6. To exit programming mode, press any remote control button except the button that was just
programmed.
7. To test, press the programmed button on the remote control...
The garage door opener will activate.
1
2
3
Program Button
5
6
32
Learn
LED
Yellow
4
Visor Clip
7
Advertisement
Table of Contents
