JUKI DDL-9000 Engineer's Manual page 27

Selecting the automatic presser lifting function
(2)
(1)
(Caution) 1. Turn ON the power again after one second or more has passed without fail.
(If the action of ON/OFF of the power is quick, setting may not be well changed over.)
2. If this function is not properly selected, the automatic presser lifter does not work.
3. If "FL ON" is selected without installing the automatic presser lifter, the starting at the start
of sewing is momentarily delayed. In addition, the touch-back switch may not work. Be sure
to select "FL OFF" when the automatic presser lifter is not installed.
Selecting the presser foot lifting by pedal
(1)
(1)
KFL setting
Selecting the automatic presser foot lifting after thread trimming
The presser foot can be lifted with the operation of
depressing the back part of the pedal by changing jumper
(1) located on the control circuit board.
Follow the silk screen indication located on the upper side
of the jumper to change.
PFL : Presser foot can be lifted by depressing the back
part of the pedal.
KFL : Presser lifting operation by pedal is not performed.
(Caution) 1. When changing the jumper, be sure to
(1)
PFL setting
(Caution) For the details of the function setting, refer
− 24
1) Pressing switch (1) in the control box, turn ON the
power switch.
2) LED will be displayed (2) (FL ON) with "beep", and
the automatic presser lifting function becomes
effective.
3) Turn OFF the switch once and again turn it ON.
4) Repeat operations 1) through 3), and LED display will
be "FL ON. The automatic presser lifting function does
not work.
FL ON : Automatic presser lifting function is effective.
FL OFF : Automatic presser lifting function does not work.
Similarly, the presser foot does not automatically go
up when programmed stitching is completed.
do the work after turning OFF the power.
If the jumper is changed while the power
is ON, the setting does not change. The
main unit may be broken.
2. When PFL is selected, the thread
trimming point will automatically
descends.
1) This function can be selected by function setting No.
55 of the SC-900.
1 : Presser foot automatically goes up after thread
trimming.
(Standard setting at the time of delivery)
(When the programmed stitcing is selected with CP-
360 panel, it works according to the setting of the
operation panel.)
0 : Automatic presser foot lifting after thread trimming
is not performed.
(Similarly, the presser foot does not automatically
go up when the programmed stitching is
completed.)
to the Instruction Manual for the SC-900.
−