JUKI DDL-9000 Engineer's Manual page 26

7) Pass cord (16) of AK device (asm.) through the
hole of the table and insert 2P connector (18) into
2P connector (19) (2P white CN9) located on the
control circuit board.
Arrange the cord with other cords using cord
clamp (20) and cable band (21) so that they do
not hang loose.
8) Bundle the cord with other cords using the cord
band supplied with the machine.
9) Remove the face plate of the machine head, and
lower the presser foot to make a state that lifting
plate (22) is pressed down. Turn solenoid shaft
(23) to the left with screwdriver (A) and tighten
screw (24) using hexagonal wrench key (B). At
this time, set the solenoid in the state that it is
pressed in the direction of the arrow mark.
(Caution) Check that there is a clearance
between the bottom face of presser bar
guide bracket (25) and the top end of
lifting plate (22) in the state that the
presser foot comes in close contact
with the throat plate.
10) When using the AK device, use it after removing
the head support rod on the table.
(A)
(22)
(25)
− 23 −
(20)
(21)
(18)
(24)
(B)
(23)
Clearance