Advertisement
7.
Remove the foam packaging from the rear section of the
8.
Locate the rear foot assembly along with the corresponding
hardware that secures it to the Spinner frame (Fig. 8).
Hardware:
M8x1.25x30mm Hex Head Bolt 8mm
Split Lock Washer
8mm Plain Washer
9.
Install the rear foot assembly (Fig. 9) and tighten hardware
using the supplied multi sized open wrench.
Note: These bolts must be torqued between 35-40 Lb-Ft (47-
54 Nm).
Spinner frame (Fig. 7).
Qty:
2
2
2
Assembly & Setup
Fig. 7
Fig. 8
Fig. 9
Advertisement
