4.
Remove the following: handle bar & its packaging (Fig. 4)
5.
Remove the: hardware pack, seat, handle bar post, and seat
post from the foam covering the front section of the Spinner
Note: Do not remove any tape holding the two front foam
packing half's until step 11.
6.
Tilt the packaged Spinner frame towards the heavy flywheel
end (Fig. 6) and remove the following: front foot assembly,
pedal set, & the rear foot assembly from their packaged
from the center packed location.
frame (Fig. 5).
location.
Assembly & Setup
Fig 4
Fig. 5
Fig 6