Shop Tools; Warehouse & Dock products; Hand Tools; Air Tools NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand.
15. Excessive air pressure and too much free Do not use this tool for other than its intended rotation may decrease life of the tool and may use. If used for other purposes, JET disclaims cause a hazardous situation. any real or implied warranty and holds itself 16.
Page 4
32. Do not lubricate the tool with combustible Your risk of exposure varies, depending on liquids, such as kerosene, diesel or jet fuel. how often you do this type of work. To reduce 33. Do not dispose of this tool with normal your exposure to these chemicals, work in a household waste.
As with any tool operation, safety of operator and bystanders should be first priority. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com.
Specifications were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
1). If an in-line oiler is not being used, add 4 or 5 drops of air tool oil (not included) into the Any missing parts or damage should be reported air inlet. immediately to your JET ® distributor. Do not use a damaged tool. Read this instruction manual...
Page 8
Lubrication Information Use a light oil containing rust inhibitors, such as SAE #10. Many JET air tools have integral oil If the air tool is not performing according to reservoirs, which should be kept filled when in-line specifications, the following are among the most oilers are not used.
Page 9
Recycling Protect the environment. Your tool contains materials which can be recovered or recycled. When its useful life has expired, please leave tool at a specialized facility. Figure 2 Recommended arrangement of air piping and air line system...
Page 10
Troubleshooting JAT-610/611 Drill Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valve closed or obstructed. Open valve; clear any obstructions.
Replacement parts Service parts are listed on the following pages. To order parts or reach our service department, call 1-800- 274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Please have the stock number and serial number of your tool available when you call, so that we may serve you quickly and accurately.
Page 13
#505610, JAT-610, 3/8-inch Pneumatic Drill – parts list Index Part No. Description Index Part No. Description JAT610-01 Motor housing 80245 Needle bearing 4x7x8 JSM7572-02 Pin 2x18.8 SM-70526 Work spindle JSM7572-03 Air inlet BB-6201Z Ball bearing 6201Z JSM7572-04 Trigger 70133 Washer 1/8in.