Time Program - Viessmann Vitotronic 200 Operating Instructions Manual

Operating program
Frost protection
Symbol Operating program
"Standby mode"
Operating programs for ventilation
Operating program
"Standby mode"
"Standard operation"
"Ventilation program"
Special operating programs
Display in the standard menu
21°C
14°C
Screed drying
Flow temperature
Fig. 9
Special operating programs
■ "Screed drying"
This function is activated by your contractor. Your
screed is dried in line with a set time program suita-
ble for the relevant building materials (temperature/
time profile). Your settings for central heating/central
cooling have no effect for the duration of screed dry-
ing.
■ "External hook-up"
Your heat pump control unit is regulated by a higher
ranking control unit.

Time program

The following explains how to enter the settings for a
time program. The special features of individual time
programs are described in the relevant chapters.
(cont.)
Function
No central heating/central cooling
■
No DHW heating
■
Frost protection for the heat pump, DHW cylinder, heating/cooling cir-
■
cuits and heating water buffer cylinder (if installed) is active.
Operating status
—
—
"Reduced"
"Standard"
"Intensive"
HC1
40°C
E
:
E
Air flow rate
No ventilation
Minimum air flow rate
Reduced air flow rate
Standard air flow rate
Maximum air flow rate
"External program"
■
The operating program was changed via a communi-
cation interface, e.g. Vitocom 100.
■ "Holiday program"
See page 31.
Note
In the extended menu, you can call up the set operat-
ing program under "Information": see page 51.
Operation
Ventilation
stage
0
1
2
3
4
21