Time Program For Central Heating Altering The Time Program For Central Heating - Viessmann Vitotronic 200 KW2 Operating Instructions Manual

Time Program for Central Heating
Altering the Time Program for Central Heating
1Time Prog. Central Htg.
1---7
1Time Prog. Central Htg.
Mo
1
Mo
16
Individual heating cycles for each day of the week
1. Open the hinged cover on the
programming unit. Select heating
circuit, activating or
for "Central heating time
12.
program". Wait until the
display shown on the left
appears.
13. / to enter the day of the
week for which you
require a different time
program.
14. for "Heating cycle
1".
15. for "Heating cycle 1
ON".
16. / to enter the start of the
cycle.
17. to confirm; the display
changes to "Heating
cycle 1 OFF".
18. / to enter the end of the
cycle.
to confirm; the display
19.
changes to "Heating
cycle 2 ON".
10. To set the start and end of heating
cycles 2 to 4, follow the procedure
described in points 6 and 9.
11. Close the hinged cover on the
programming unit.
To scan the heating cycle timer
Follow the procedure described above,
but without using the
buttons.
The heating cycles at a glance
1. Open the hinged cover on the
programming unit.
2. Press and simultaneously; the
preset heating cycles for the current
day of the week appear on a time
slot graphic.
3. Close the hinged cover on the
programming unit.
(continued)
or .
If you wish to exit the time program
setting mode, press
Press
After you have confirmed the last
input with
and shows the boiler water
temperature.
and
again.
to skip a timer cycle.
, the display changes