Njoy Aten PRO Series User Manual page 10

Parameter 1
01: Output voltage settings
02: Frequency Converter enable/disable
03: Output frequency settings
18
Settings
Parameter 3: you may choose the
following output voltage:
200: presents output voltage is 200Vac
208: presents output voltage is 208Vac
220: presents output voltage is 220Vac
230: presents output voltage is 230Vac
(Default)
240: presents output voltage is 240Vac
NOTE: Derate to 80% of capacity
when the output voltage is adjusted to
200/208Vac.
Parameter 2&3: Enable or disable
converter mode. You may choose
the following two options:
CF ENA: converter mode enable
CF DIS: converter mode disable
(Default)
NOTE: Derate to 80% of capacity in
Frequency converter mode.
Parameter 2&3: Output frequency
setting. You may set the initial
frequency on battery mode:
BAT 50: presents output frequency
is 50Hz
BAT 60:
is 60Hz
If converter mode is enabled, you
may choose the following output
frequency:
CF 50:
is 50Hz
CF 60:
is 60Hz
04: ECO enable/disable
Parameter 3:
ECO function. You may choose the
following two options:
ENA:
DIS:
05: ECO voltage range settings
Parameter 2&3:
acceptable high voltage point and
low voltage point for ECO mode by
pressing Down key or Up key.
HLS:
mode in parameter 2 (the setting
range in parameter 3 is from +7V
to +24V of the nominal voltage -
Default: +12V)
LLS:
in parameter 2 (the setting range
in parameter 3 is from -7V to -24V
of the nominal voltage - Default:
-12V)
presents output frequency
presents output frequency
presents output frequency
Enable or disable
ECO mode enable
ECO mode disable (Default)
Set the
High loss voltage in ECO
Low loss voltage in ECO mode
19