Yaesu DR-1X Installation Instructions Manual page 9

Hide thumbs Also See for DR-1X:

New set item added to [ID ANNOUNCE]

In the Setup menu, touch [ID ANNOUNCE] and then touch [ANNOUNCE].

"CW wo TONE" and "VC wo TONE" have been newly added to the ANNOUNCE mode.

When "CW wo TONE" is selected, The CTCSS TONE or DCS code (or other code) will not be added to the

signal while the INTERVAL CW ID is transmitted.

When "VC wo TONE" is selected, The CTCSS TONE or DCS code (or other code) will not be added to the

signal while the voice ID announcement is being transmitted.

Note

Please note the following regarding operation of the repeater ID when the ANNOUNCE mode is set

to "CW wo TONE" or "VC wo TONE".

1. During initial activity after the DR-1X/XE is first powered on; the ID is sent with tone when the

ANNOUNCE mode is set to "CW wo TONE" or "VC wo TONE".

2. During repeater inactivity the ID will be sent without tone when "CW wo TONE" or "VC wo TONE" is

selected.

3. If the DR-1X/XE is sending the ID and a user transmits, the incoming audio is muted until the ID is

finished being sent when "CW wo TONE" or "VC wo TONE" is selected.

4. When the DR-1X/XE is active and the ID timer expires, the ID is sent with tone when "CW wo TONE" is

selected. The ID and ongoing audio are mixed.

5. When the DR-1X/XE is active and the ID timer expires, the ID is sent with tone when "VC wo TONE" is

selected. The Voice ID and ongoing audio are not mixed, the ongoing audio is muted while the Voice ID

is sent.

Dr-1xe