Note
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before
•
restarting the unit. If you attempt to restart it before this time delay, the wine cabinet will not
start.
• When you use the wine cabinet for the first time or restart the cabinet after having been shut
off for a long time, there could be a few degrees variance between the temperature you select
and the one indicated on the LED readout. This is normal and it is due to the length of the
activation time. Once the wine cabinet has been running for a few hours everything will be
back to normal.
Internal light
In order to reduce energy consumption, the LED light within this wine cabinet will
automatically switch off after 10 minutes. If you would prefer the LED light to remain on
continuously, this is possible. Please press and hold the "LIGHT" button for 5 seconds, the
display will show "LP". After 4 seconds the display will revert back to normal and the light
will remain on until manually switched off.
If you would like to revert back and conserve energy (recommended), press and hold the
"LIGHT" button for 5 seconds, the display will show "LF". After 4 seconds the display will
revert back to normal, and the light will automatically switch off after 10 minutes.
Using the shelves
To prevent damaging the door gasket, make sure you have the door fully open when pulling
•
shelves out of the rail compartment.
For easy access to the storage content you must pull the shelves approximately 1/3 out of the
•
compartment, however this unit is designed with a notch on each side of the shelf tracks to
prevent bottles from falling.
Removing or installing shelves
When removing any of these shelves from the rail compartment tilt the shelf as per the
•
diagram below and simply pull it out, or to install a shelf push it in until it sits on the support
brackets securely.
6