Operating you wine cabinet and setting the temperature How to change the door opening Installing the bar handle Installation dimensions Installing the top bracket Care and maintenance Troubleshooting guide Caple Service contact details Defrosting/condensation The humidity system Recommended storage temperatures Recommended drinking temperatures...
The wine cabinet should be installed in a suitable place in order to avoid touching the l compressor with the hand. If the supply cord is damaged, it must be replaced by a Caple service agent or a similarly l qualified person in order to avoid a hazard.
(ground) pin from the plug. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorised Caple service centre. To protect the appliance in transit and delivery the door is packed tightly against the cabinet. When...
Operating your wine cabinet and setting the temperature Please use the cabinet within a ambient temperature range of 16-32 ºC. If the ambient temperature is higher than or lower than this temperature, it will cause the temperature to fluctuate in the cabinet. Your appliance may not be able to reach 5-18 ºC. Control Panel “Light”...
How to change the door opening This appliance has reversible doors but is delivered with a right hinged door. The left hand hinge kit comes with the unit (in the box), should you wish to reverse the hinge on your unit follow the directions below: 1.
If you would like to revert back and conserve energy (recommended), press and hold the "LIGHT" button for 5 seconds, the display will show "LF". After 4 seconds the display will revert back to normal, and the light will automatically switch off after 10 minutes. Installing the bar handle Remove the door gasket on the drilling holes side to install the handle.
After installing the wine cabinet, please open the door, adjust the fixing bracket (a) and fix this in position with the screw (c) using a screwdriver (d) into the work surface/kitchen cabinet. a) Top fixing bracket b) Kitchen Cabinet c) Screw d) Screwdriver This bracket will keep the product secure and help prevent it moving when in use...
Care and Maintenance Cleaning your wine cabinet Turn off the power, unplug the appliance, and remove all items including shelves and rack. • Wash the inside surfaces with a warm water and baking soda solution. The solution should be • about 2 tablespoons of baking soda to a quart of water.
Problems with your wine cabinet You can solve many common wine cabinet problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling Caple Service. Troubleshooting guide...
Defrosting/condensation Your wine cabinet is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine cabinet (interior rear wall) defrosts automatically. The defrosted water is channelled into a drain pan which is located at the back of the cabinet next to the compressor from where it evaporates.