Subscribe to Our Youtube Channel
Related Manuals for Caple WI6225
Summary of Contents for Caple WI6225
- Page 1 Instruction manual for slot-in wine cabinet Model code: WI6225 Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.uk...
-
Page 2: Important Safety Instructions
The wine cellar should be installed in a suitable place in order to avoid touching the compressor with the hand. If the supply cord is damaged, it must be replaced by a Caple service agent or a similarly qualified person in order to avoid a hazard. -
Page 3: Installation Instructions
INSTALLATION INSTRUCTIONS Before using your wine cabinet Remove the exterior and interior packing. • Before connecting the Wine cabinet to the power source, let it stand upright for • approximately 12 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. - Page 4 Control system instruction “Run” • Indicator light illuminates to signify the cooling mode is currently in operation. “Light “Button • To control the inner light turn on/off. “Power” Button • ( press and hold this buttons for approximately To control this appliance turn on/off 3 seconds).
- Page 5 temperature you select and the one indicated on the LED readout. This is normal and it is due to the length of the activation time. Once the Wine cabinet is running for a few hours everything will be back to normal. Shelves To prevent damaging the door gasket, make sure you have the door fully open when •...
-
Page 6: Care And Maintenance
Installation diagram CARE AND MAINTENANCE Cleaning your wine cabinet Turn off the power, unplug the appliance, and remove all items including shelves and • rack. Wash the inside surfaces with a warm water and baking soda solution. The solution • should be about 2 tablespoons of baking soda to a quart of water. -
Page 7: Troubleshooting Guide
PROBLEMS WITH YOUR WINE CABINET? You can solve many common Wine cabinet problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE Not plugged in. - Page 8 DEFROSTING/CONDENSATION Your wine cellar is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine cellar (interior rear wall) defrosts automatically. The defrost water is channelled into a drain pan which is located at the back of the wine cellar next to the compressor from where it evaporates.
Need help?
Do you have a question about the WI6225 and is the answer not in the manual?
Questions and answers