Using The Shelves - Caple Wi3119 Instruction Manual

Note
If the unit is unplugged, power lost or turned off, you must wait 3 to 5 minutes before restarting
•
the unit. If you attempt to restart before this time delay, the wine cabinet will not start.
• When you use the wine cabinet for the first time or you restart the cabinet after having been shut
off for a long time, there could be a few degrees variance between the temperature you select
and the one indicated on the LED readout. This is normal and it is due to the length of the
activation time. Once the wine cabinet has been running for a few hours everything will be back
to normal.
Internal light
In order to reduce energy consumption, the LED light within this wine cabinet will automatically
switch off after 10 minutes. If you would prefer the LED light to remain on continuously, this is
possible. Please press and hold the "LIGHT" button for 5 seconds, the display will show "LP".
After 4 seconds the display will revert back to normal and the light will remain on until manually
switched off.
If you would like to revert back and conserve energy (recommended), press and hold the
"LIGHT" button for 5 seconds, the display will show "LF". After 4 seconds the display will revert
back to normal, and the light will automatically switch off after 10 minutes.

Using the shelves

To prevent damaging the door gasket, make sure to have the door opened fully when pulling
•
shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately 1/3 out of the rail
•
compartment, however this unit was designed with a notch on each sides of the shelf tracks to
prevent bottles from falling.
Removing or installing shelves
To install or remove a shelf, tilt the shelf as per the diagram and simply pull out, or push in the
•
shelf until it sits on the support brackets securely.
6