Table of Contents
Advertisement
30
www.electrolux.com
5. Lift and turn the lever on the left
hinge.
6. Close the oven door halfway to the
first opening position. Then pull
forward and remove the door from its
seat.
7. Put the door on a soft cloth on a
stable surface.
8. Hold the door trim (B) on the top
edge of the door at the two sides and
push inwards to release the clip seal.
2
B
9. Pull the door trim to the front to
remove it.
10. Hold the door glass panels by their
top edge and carefully pull them out
one by one. Start from the top panel.
Make sure the glass slides out of the
supports completely.
11. Clean the glass panels with water
and soap. Dry the glass panels
carefully.
When the cleaning is completed, install
the glass panels and the oven door. Do
the above steps in the opposite
sequence.
Make sure that you put the glass panels
(A, B and C) back in the correct
sequence. The middle panel (B) has a
decorative frame. The screen-printing
zone must face the inner side of the
door. Make sure that after the installation
the surface of the glass panel frame (B)
on the screen-printing zones is not rough
when you touch it.
1
Advertisement
Table of Contents
