Controller Menu - DIG LEIT RC2ET Instruction Manual

Two-way weather based radio remote control handset
Hide thumbs Also See for LEIT RC2ET:
Table of Contents

Advertisement

Repeat the steps to select a new ID. When finished, press
upload the new information. ARE YOU SURE? screen appears. Press
to download the information. UPDATE SUCCESSFUL message will appear
momentarily, confirming that the controller received the information and setup
is updated and complete. After the update is completed the CONTROLLER
MENU appears. The controller may now be programmed (section 4).
The user can now easily connect back to this controller using the newly
assigned CONTROL ID and CLIENT ID. Repeat the steps to program additional
controllers. Repeat the steps to program additional new controllers.
NOTE: When connecting to a LEIT-2ET controller, the controller CLIENT ID must be the same
as on the handset and controller.
ATTENTION: The two (2) yellow or yellow and black sensor wires are left connected, so the
RAIN OFF alert will not appear. If a rain sensor needs to be added, see Sensor Installation in
the LEIT-2ET controller instruction manual.
NOTE: Where multiple LEIT-2ET controllers are installed within range of the LEIT RC2ET, make
sure to assign different CONTROLLER ID numbers, one at a time.
4.
Controller Menu
After connecting to a LEIT-2ET controller, press
review the Controller ID and available controller information
until the CONTROLLER MENU appears. The CONTROLLER
MENU screen is used to perform functions such as Manual
Run or Manual Test, set a program for each valve, activate
ET if a weather station is installed within range, check
History Reports, review Controller Status information, adjust
seasonal Budget, program Rain Delay, Wind Stop and Stop Irrigation for any
specific month of the year, as needed.
10:00
10:00
MAIN MENU
10:00
10:00
CONNECTED
CONNECT
10:00
10:00
CONNECTING
CONNECT
17
to connect and
10:00
CONTROL ID: 00
NO DESCRIPTION
RADIO UPLINK
RADIO UPLINK
10:00
UPLOADING
CONTROL ID: XX
NO DESCRIPTION
e
HW: 1.
SW: 3.16
CONNECTED TO
and
10:00
UPDATE
SUCCESSFUL
CONNECT

CONTROLLER MENU

again
10:00
ARE YOU
YES /
10:00
CONTROL
NO DESCR
CLIENT ID:
CONNECT
CONT. S

Advertisement

Table of Contents
loading

Table of Contents