General Information For Handset And Controller - DIG LEIT RC2ET Instruction Manual

CONTROLLER MENU
10:00 10:00
7. Exit Environment Menu:
In the ENVIRONMENT menu screen, highlight the EXIT icon. Press
SET SENSOR:
ENVIRONMENT screen and the CONTROLLER MENU screen appears. If the
8 mph
handset is left on, it will turn off automatically in ten (10) minutes.
WIND SENSOR
10:00 10:00
ENVIRONMENT
8. General Information for Handset and Controller
1) The LEIT-2ET wireless irrigation controller needs adequate light to maintain proper
function. At low light levels the radio will periodically turn off to guarantee correct
controller operation. When the radio is off, less power is used and the radio can turn
itself on again when sufficient light has charged the controller to adequate levels.
2) The radio will function better if the controller is located at higher elevation. If there
is a choice do not situate the controller in a hollow area.
3) To communicate, the controllers and handsets MUST have the same CLIENT ID Code.
This is the user's unique identification code, which prevents interference from other
users in the area.
4) If two controllers are set to the same ID, communication may be disrupted if both
controllers are in range of the handset. The same occurs if two handsets are set
to the same ID and are in use at the same time. All controllers and handsets in the
same group must have a unique ID. (We recommend setting controller and handset
starting from #2.)
5) The handset needs to be kept in a charged state. After 500-1,000 charge cycles the
internal batteries may need replacement.
IMPORTANT: Communication between the LEIT RC2ET handset and the LEIT-2ET controller
is automatically limited to daylight hours between 8 AM to 5 PM, when there is sufficient
light energy. Longer bright light days will enable the radio to operate automatically over
longer parts of the day, into the evening.
ENVIRONMENT WIND SENSOR
10:00
ARE YOU SURE? DOWNLOADING
CONNECT
YES / NO
10:00
EXIT CONTROLLER MENU
CONNECT
10:00
CONNECTED
CONNECT
45
CONNECT
10:00
UPDATE
to exit
SUCCESSFUL
CONNECT