Installation; Mounting The Outboard Motor On Boat - TOHATSU M 40D2 Owner's Manual

INSTALLATION

ENOM00024-A
1. Mounting the outboard
motor on boat
ENOW00006-B
WARNING
Before installing the outboard motor on the
boat, hang the outboard motor with the
hoist or equivalent device by attaching the
engine hanger to the outboard. Use the hoist
with allowable load is 250 kg (550 lbs) or
above.
ENOW00006-0
WARNING
Most boats are rated and certified in terms
of their maximum allowable horsepower, as
shown on the boat's certification plate. Do
not equip your boat with an outboard motor
that exceeds this limit. If in doubt, contact
your dealer.
Do not operate the outboard motor until it
has been securely mounted on the boat in
accordance with the instructions below.
ENOW00009-
Mounting the outboard motor without
following this manual can lead to unsafe
conditions such as poor maneuverability,
lack of control or fire.
Loose clamp screws and/or mounting
bolts can lead to the release or displace-
ment of the outboard motor, possibly
resulting in lost of control and/or serious
personal injury. Be sure that fasteners are
tightened to the specified torque (30 Nm
(3.0 kgf) 13 ft-lb). Check the fasteners for
tightness from time to time.
Be sure to use outboard mounting fasten-
ers included in the outboard motor pack-
age or their equivalents in terms of size,
material, quality and strength.
Outboard motor mounting must be per-
formed by trained service person(s) using
lift or hoist with sufficient capacity.
ENOM00025-C
Position... Above keel line
Single-engine Installation
Place the outboard motor in the center
of the boat's transom
ENOF01313-0
1. Center of boat
2. Boat transom
WARNING
1
ENOF01141-0
25
5
2