Fuel Feeding - TOHATSU M 40D2 Owner's Manual

2
3
1. Rod snap
2. Control lever
3. Open side position
4. link rod
5. Advancer arm
ENOM00044-E

2. Fuel feeding

ENOW00029-A
WARNING
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
could blast out through the fuel tank cap in
case the cap is loosened by using another
procedure when internal pressure of fuel
tank is raised by heat from sources such as
sun light.
1. Full open the air vent screw on the
fuel tank cap.
1. Air vent screw
2. Fuel tank cap
2. Open the fuel tank cap slowly and
3. Connect the fuel connector to the
ENOF00652-B
1. Fuel connector
2. Pull
3. Insert
1. Pull
2. Insert
4. Squeeze primer bulb until it becomes
1
2
1. Engine side
2. Fuel tank side
ENOF00027-B
ENGINE OPERATION
release internal pressure completely.
After that, close the fuel tank.
engine and fuel tank.
1
2
2
1
stiff to feed fuel to carburetor. Direct
arrow mark upward when priming.
1
2
41
3
ENOF01905-0
7
ENOF00861-A
ENOF00862-0