Table of Contents
Advertisement
O c t ober , 20 0 5
4 1 5 L LS Ope ra tor And
4 2 5 D C o ntrol Pa ne l I nsta lla ti on Ma nua l
P
ROGRAMMING
WARNING! Turn off the main power before you
make any electrical connections or set any
switches inside the control panel box.
To
program
the
automated
"Programming Mode" must be accessed.
The 425D has two push buttons labeled P1 and
P2 that are used to program how the control
panel operates and responds to inputs.
1. The display should show "— —".
2. Press and hold the P2 button for 5 seconds
until the display shows the first parameter.
3. To change the parameter values use the P1
button.
4. Use the P2 button to move from parameter to
parameter.
5. If no buttons are pushed for 60 seconds then
the
board
will
programming.
6. Continuing all the way through the program
to the last parameter will also exit the
program.
Use the following table to program the
parameters required for your installation.
PROGRAM BUTTONS
Left
P1
DISPLAY
FORCE SETTING (Force Applied to the Gate)
Medium low force, maximum
Medium high force, minimum
system,
the
automatically
exit
Right
P2
DESCRIPTION
Minimum force, maximum
sensitivity
sensitivity
sensitivity
Maximum force, minimum
sensitivity
DISPLAY
LEAF DELAY
LOGIC SETTING
ACTIVITATION COMMAND
SECURITY MODE
Only useful in EP Logic
REVERSING STROKE (useful with electric locks)
COURTESY LIGHT/WARNING LIGHT
Courtesy Light (Light stays lit solid for
DECELERATION PERCENTAGE SETTING
20% of opening run time
10% of opening run time
DECELERATION SPEED (SLOW DOWN SPEED)
LIMIT SWITCHES (WITH/WITHOUT)
Not using limit switches
NUMBER OF MOTORS
One operator connected
Two operators connected
DESCRIPTION
1.5 seconds
3 seconds
6 seconds
10 seconds
E P
A
Open/Close/Open
Open/Stop/Close/Stop
Only useful in A Logic
Disabled
Enabled
Flashing Light
90 seconds)
High
Low
Using limit switches
P ag e 1 9
Advertisement
Table of Contents
