Programming Gate Movement Variables - FAAC Estate Swing E-S 1100 Series Instruction Manual

Estate Swing
Using the following procedures you can change factory settings such as auto
close, speed, force, delays and more.
B: Switches between the amount of time the gate pauses befor e closing after r eaching
full open. By selecting Logic EP (4) all pause times will be void and the gate will remain
open until an opening devices is triggered.
C: Switches between the amount of time the gate waits befor e beginning motion when
an opening and closing is triggered or if dual gates are installed, pause time will only apply
to one gate.
D: Switches between the amount of for ce the gate opener will exer t befor e an obstr uc-
tion is detected and the gate reverses directions.
E: Switches between the speed of the gate motion. This does not effect the soft star t
and stop.
See the following page for Gate Movement Variables LED Chart .
Controlling the Master Leaf with either the Master or Slave Control Board
With this function you can select the leaf you wish to move with the Master Control Board.
Press and hold down P1, then press and hold down P2. LED A starts flashing. Using P2 move
from LED 1 to LED 2 according to the desired leaf control as described below:
LED 1 lit - Master controls leaf 1 (default)
NOTE: The oper ation of the Slave Contr ol Boar d is automatically set accor ding to the Master Contr ol
Board.
6.1

Programming Gate Movement Variables

Begin the programming process by pressing P1. Pressing P1 se-
lects A,B,C,D or E. A, B, C, D and E correspond with the varia-
bles in the chart on the following page.
When you are on the desired variable you would like to change the
setting of press P2 to change the setting of that variable. P2 will
change the light to 1, 2, 3 or 4 which correspond with the settings
on the chart below on the following page. Below is a list what each
variable controls.
A: Switches between Function Logics. Function Logics ar e sets
of actions that will occur when an accessory terminal connection is
made or disrupted. Each set of actions is designed to give different
results providing increased safety, convenience or other.
LED 2 lit - Master controls leaf 2