KVSP Owner’s Manual CONTENTS SPECIFICATIONS AND SOUND/VIBRATION INSTRUCTION LABELS PACKING CHECKLIST & ASSEMBLY ASSEMBLY OPERATION MAINTENANCE 9-11 TROUBLESHOOTING ILLUSTRATED PARTS & PART LISTS 13-15 DECLARATION OF CONFORMITY 16-18 Go to http://www.billygoat.com for French-Canadian translations of the product manuals. Visitez http://www.billygoat.com pour la version canadienne-française des manuels de produits.
INSTRUCTION LABELS ® The labels shown below were installed on your BILLY GOAT KV Vacuum. If any labels are damaged or missing, replace them before operating this equipment. For your convenience in ordering replacement labels, part numbers are included in the Illustrated Parts List.
KVSP Owner’s Manual PACKING CHECKLIST Your Billy Goat KV Vacuum is shipped from the factory in one carton, completely assembled except for the upper handle, debris bag, and bag quick disconnect. READ all safety instructions before assembling unit. TAKE CAUTION when removing the unit from the box, the Handle Assembly is attached by cables and folded over.
KVSP Owner’s Manual ASSEMBLY NOTE: Items in ( ) can be referenced in the Parts Illustration and Parts List on pages 13-15. 1. ASSEMBLE the upper handle (item 11), with the hardware from the parts bag (items 50, 49, and 51) to the lower handle (item 10).
KVSP Owner’s Manual OPERATION VACUUMING OPERATION VACUUM NOZZLE HEIGHT ADJUSTMENT: Nozzle height is raised and lowered by rotating the red knob near the left rear wheel. Nozzle height should be adjusted based on the task being performed (see Fig. 4). FOR MAXIMUM PICKUP: Adjust nozzle close to debris, but without blocking airflow into the nozzle.
Page 8
KVSP Owner’s Manual MULCH Wood chips made from branches in your own yard make excellent mulch. A thick blanket of wood chips around plants and flowers to keeps weeds out and moisture in. CHIPPER OPERATION (TKV only) Your TKV chipper is designed to process tree branches and limbs up to 2" (50.8mm) diameter (see Fig.
8. Lift impeller upward. If impeller slides freely, proceed to step 10. 9. If the impeller does not loosen, obtain a 3/4-16x3” (Billy Goat P/N 440192) or longer bolt. Thread bolt by hand into nut until bolt rests against the shaft. Tighten the bolt slowly, which will pull the impeller away from the shaft, remove impeller from shaft.
Page 10
8. Lift impeller upward. If impeller slides freely, proceed to (step 10.) 9. If the impeller does not loosen, obtain a 3/4-16x3” (Billy Goat P/N 440192) or longer bolt. Thread bolt by hand into nut until the bolt rests against the shaft. Tighten the bolt slowly, which will pull the impeller away from the shaft. Remove the impeller from the shaft.
Page 11
® required. If reassembly requires a different quantity of shim washers, a Billy Goat shim washer must be used (P/N 890130 or P/N 890131, whichever is required).
KVSP Owner’s Manual TROUBLESHOOTING Problem Possible Cause Solution Abnormal vibration Loose or out of balance impeller or loose Check impeller and replace if required. engine. Check engine. Will not vacuum or has poor Dirty debris bag. Hose kit cap missing. Clean debris bag.
KVSP Owner’s Manual KVSP/TKVSP PARTS DRAWING Part No 891204 891204_A_HI...
Page 14
KVSP Owner’s Manual KVSP/TKVSP PARTS LIST ITEM KV601SP/KV601SPF KV650SPH/KV650SPHFB TKV650SPH/TKV650SPHF Description B PART NUMBER PART NUMBER B PART NUMBER MAIN FRAME HOUSING KV 891100-S 891100-S 891100-S NOZZLE ASSEMBLY TKV 891110-S 891110-S 891110-S AXLE WA KV MICRO 891138 891138 891138 PLATE TOP WA KVSP...
Page 15
KVSP Owner’s Manual KV601SP/KV601SPFB KV650SPH/KV650SPHFB TKV650SPH/TKV650SPHFB PART NUMBER PART NUMBER PART NUMBER SCREWCAP 1/4 - 20 x 5/8 HWH 890359 890359 890359 BOLT IDLER 3/8-16 X 1 1/2 800888 800888 800888 WASHER 1/4" SAE ZP 8172007 8172007 8172007 WASHER 5/16 FLATWASHER Z/P...
KVSP Owner’s Manual Руccкий English Suomi Latviešu Slovenščina български език Nederlands Français Čeština Ελληνικά Slovák Norsk Svenska Dansk Hrvatski Polski Türkçe Deutsch Magyar Português Română Español Italiano Lietuvių eesti keel Δήλωση συμμόρφωσης ΕΚ Deklaracja zgodności UE EC Declaration of Conformity Декларация...
Page 17
89 dB(A) 4.85 kW 4.95 m/s 51.3 kg KV650HFB 104.2 dB(A) 103.2 dB(A) 88.4 dB(A) 3.69 kW 2.83 m/s 60.3 kg KV601SP 104.2 dB(A) 103.2 dB(A) 88.4 dB(A) 3.69 kW 2.83 m/s 60.3 kg KV601SPFB 110 dB(A) 109 dB(A) 89 dB(A) 4.85 kW...
Page 18
KVSP Owner’s Manual (1) ISO 5395-1:2013 F.7 (EN 4871:1996) (2) ISO 5395-1:2013 G.8 (EN 12096:1997, D.1) Τόπος κατασκευής / Υπεύθυνος τήρησης αρχείων Miejsce produkcji / Osoba odpowiedzialna za Manufacturing Place / Keeper of Documentation Място на производство / Архивар τεκμηρίωσης przechowywanie dokumentów Gyártás helye / A dokumentáció...
Need help?
Do you have a question about the KV601SP and is the answer not in the manual?
Questions and answers