Table of Contents
Advertisement
TRANSMITTER PROGRAMMING
STEP 1 - Open the hood.
STEP 2 - Turn ignition key ON-OFF-ON-OFF-ON Leaving Key ON.
STEP 3 - Hold brake down until lights flash and LED's come on solid.
About 5 seconds.
STEP 4 -Siren/horn will chirp 5 times and leds will stay on solid.
STEP 5- Press the lock button on each transmitter to be programmed.
The park lights will flash 1 time each time a transmitter is learned.
NOTE : All transmitters to be used must be programmed at the same time
. Any transmitter not programmed in the same sequence will be erased from
the systems memory.
SYSTEM RESET to DEFAULT Settings
STEP 1 - Enter Program Mode by turning ignition key ON-OFF-ON-OFF-ON (Leaving Key ON).
STEP 2 - Press the Valet (program) Button, located on the antenna 1 time and release.
Siren/Horn will chip once.
STEP 3 - Press and hold button #4 for two seconds.
STEP 4 - Siren will chirp twice Continue to hold valet until park lights and siren go on and off
three times.
System is now re-set to factory defaults.
TRANSMITTERS
Lock Doors
Arm Alarm
Remote Start
Aux.
EMERGENCY VALET MODE - All Models
ENTERING VALET MODE
1. While ignition is "on" press and hold the antenna button for 5 seconds until siren chirps 5
times.
2. Alarm and remote start functions will be disabled and LED will be "on" steady. Door locks
and trunk release are still operational.
EXITING VALET MODE
1. While ignition is "on" press and hold the antenna button for 5 seconds until siren chirps 2
times.
Note: System can be programmed into "High Security Mode" to enhance or disable this
feature, check with installation center.
# 1
# 3
# 2
Unlock Doors
Disarm Alarm
# 4
Car Finder
Aux
Advertisement
Table of Contents
