Advertisement
Quick Links
Advertisement
Related Manuals for Ultra Start 2250M
Summary of Contents for Ultra Start 2250M
- Page 1 FCC/ID Notice...
- Page 2 NSTALLATION UIDE TABLE OF CONTENTS...
-
Page 3: Installation
NSTALLATION UIDE WIRING DIAGRAM... -
Page 4: Installation Tips
INSTALLATION GUIDE INSTALLATION TIPS... -
Page 5: Wiring Connections
INSTALLATION GUIDE Second Starter Second Accessory Second Ignition* WIRING CONNECTIONS 12volts during crank only. 12volts in accessory. Off during start. Constant 12volt power at ignition harness. Constant 12volt power at ignition harness. 12volts in ignition and start positions. Selectable Output. See jumper diagram. Starter Program Mode. - Page 6 QUICK START INSTALL QUICK START INSTALL See Page 12. INSTALLATION GUIDE High Current. High Current.
- Page 7 INSTALLATION GUIDE PROGRAMMING PROGRAMMING If the unit does not enter Program Mode, turn the ignition off for five seconds and repeat steps 1-4. (See pages 8 - 11) as listed on pages 8 - (Leaving Key ON).
- Page 8 INSTALLATION GUIDE PROGRAMMING PROGRAMMING...
- Page 9 INSTALLATION GUIDE PROGRAMMING PROGRAMMING Enter Alarm Program Mode - See Page 7 for details on entering program mode...
- Page 10 INSTALLATION GUIDE PROGRAMMING...
- Page 11 INSTALLATION GUIDE PROGRAMMING During countdown After full alarm...
- Page 12 INSTALLATION GUIDE OPERATIONS Note:...
- Page 13 INSTALLATION GUIDE OPERATIONS Note: The siren will chirp 5 times to confirm Service Mode was entered. Note: The siren will chirp 2 times to confirm Service Mode was exited. LIMITED LIFETIME WARRANTY Available with Professional Installation Only...
- Page 14 INSTALLATION GUIDE OPERATIONS LOCK UNLOCK LOCK & UNLOCK UNLOCK LOCK LOCK UNLOCK 2 Times if programmed for safety start...
- Page 15 INSTALLATION GUIDE OPERATIONS LOCK...
- Page 16 Bypass Unit Ignition Start Main Unit Starter Motor DIAGNOSTICS...