Transmitter Programming - Ultra Start 72 Series Owner's Manual

72 SERIES
OWNER'S MANUAL
The system can lean up to 4 different remote's. Each remote to be used MUST be
programmed together during the same sequence. For security, when a new remote is
programmed all previous remote's are deleted. Please see remote operation chart for
information on using Second Car / Pad Lock Operations.
ENTERING REMOTE PROGRAM MODE
1 -
2 -
3 -
PROGRAMMING REMOTE'S
Press & Release LOCK button on 1st Remote to be Programmed for Normal
4 -
Operation If remote(s) are to be programmed for "PADLOCK" skip and
goto step 6
HORN will Honk 1 time to confirm remote has been
5 -
programmed (If the HORN does not Honk press button again)
REPEAT STEP 4 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR NORMAL OPERATION
Press & Release BUTTON 4 on Remote to be Programmed
6 -
for 2ND CAR OR PAD LOCK
HORN will Honk 1 time to confirm remote has been
7 -
programmed (If the HORN does not Honk press button again)
REPEAT STEP 6 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR 2ND CAR / PADLOCK OPERATION
Turn ignition key OFF to exit remote program mode when
8 -
all required remote's have been programmed.
Cycle the Ignition Key - ON/OFF ON/OFF ON (Leaving the key ON)
HOLD program switch, the HORN will Honk ONCE and the park lights will turn on.
(If the HORN does not Honk repeat step 1)
CONTINUE TO HOLD until HORN Honks 5 times
1 Honk confirms program mode entered followed by 5 Honks confirming
transmitter program mode
REMOTE PROGRAMMING
PAGE 14