Table of Contents
Advertisement
BASIC INSTALLATION - QUICK START
STEP 1 -
The following wires MUST be connected for proper operation.
6 Pin Power Connector - Connect the following:
WIRE
FUNCTION
RED-1
Main Power
RED-2
Main Power
BLUE
Ignition
YELLOW
Starter
GREEN
Accessory
BLACK
System Ground
14 Pin Accessory Connector - Connect the following:
WIRE
FUNCTION
White
Parking Lights
Green/White
Hood Pin Safety
Blue/white
Tach Input (-/+)
Blue
Brake Pedal
Green
Door Trigger
Purple
Door Trigger
Brown
Siren/Horn
STEP 2 -
Plug the Connectors into the Unit
Plug the 6 Pin Connector into the Remote Starter module then plug the 14 Pin
and any other connectors into unit.
***Make sure that Ignition Key is in the OFF position****
STEP 3 - Tach Selection - Default Tachless
Method 1-
Voltage sensing. System will sense a increase in voltage and
stop cranking.
Method 2- Tachless timer mode. Starter stops cranking at a pre-determined
crank time.
Method 3-
Tach learning. System will sense tach pulses from the vehicle.
See tach and voltage settings in the Program Guide
MANUAL TRANSMISSION
NOTE : Place dip switch #2 in the "ON" position
"Reservation Mode"
SHOCK SENSOR ADJUSTMENT - Alarm Models ONLY
Input
(+)
Input
(+)
Output
(+)
Output
(+)
Output
(+)
Input
(-)
Output
(+)
Input
(-)
Input
(-/+)
Input
(+)
Input
(-)
Input
(+)
Output
(+)
must be activated each time vehicle is exited to remote start
Shock Sensor
2000 Series
Connect to on Vehicle
Constant 12V (+) at Ignition Harness
Constant 12V (+) at Ignition Harness
Main Ignition (+) at Ignition Harness
Starter Wire (+) at Ignition Harness
Heater wire
(+) at Ignition Harness
Ground on Vehicle (-)
Connect to on Vehicle
12v(+) Parking Lights
Hood Pin Switch (-) when hood open
A/C tach source (Optional)
12v when brake pedal is pressed
Switches to (-) when door opens
Switches to (+) when door opens
Connect to siren or to factory horn
Adjustment
Min.
Max.
Advertisement
Table of Contents
