Transmitter Programming; Programming Remote Transmitters - Ultra Start 1172 Installation Manual

72 SERIES
INSTALL MANUAL
The system can lean up to 4 different remote's. Each remote to be used MUST
be programmed together during the same sequence. For security, when a new
remote is programmed all previous remote's are deleted. Please see remote
operation chart for information on using Second Car / Pad Lock Operations.
ENTERING REMOTE PROGRAM MODE
Cycle the Ignition Key - ON/OFF ON/OFF ON
1 -
(Leaving the key ON)
HOLD the program switch, the HORN will honk ONCE and the park lights will
2 -
turn on. (If the HORN does not honk repeat step 1) CONTINUE TO HOLD until
the HORN honks 5 times
1 honk confirms program mode entered followed by
3 -
5 honks confirming transmitter program mode
PROGRAMMING REMOTE'S
Press & Release LOCK (START ON 1172) button on 1st Remote to be
4 -
Programmed for Normal Operation If remote(s) are to be
programmed for "PADLOCK" skip and goto step 6.
HORN will honk 1 time to confirm remote has been
5 -
programmed (If the HORN does not honk press button again )
REPEAT STEP 4 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR NORMAL OPERATION
Press & Release BUTTON 4 on Remote to be Programmed
6 -
for 2ND CAR OR PAD LOCK
HORN will honk 1 time to confirm remote has been
7 -
programmed (If the HORN does not honk press button again)
To program 2nd car operation on 2way models enter transmitter program mode and turn the # icon
on then program the transmitter to the vehicle. If the # icon is on the remote is in 2nd car operation
REPEAT STEP 6 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR 2ND CAR / PADLOCK OPERATION
Turn ignition key OFF to exit remote program mode when
8 -
all required remote's have been programmed.
SYSTEM PROGRAMMING - Menu 1

TRANSMITTER PROGRAMMING

PAGE 8
.