Transmitter Programming; Battery Replacement - Ultra Start 12 SERIES Install Manual

REMOTE VEHICLE STARTER

Transmitter Programming

Step 1 - Within 3 seconds turn the ignition ON-OFF-ON-OFF-ON - Leaving Key ON
Step 2 - Press and hold the Program Button - The park lights will turn ON and the horn(optional) will honk once.*
Continue to hold the Program Button, the park lights will turn off and the horn will honk 5 times quickly.
Step 3 - While holding the Program Button, press the LOCK button on each of the remote's to be programmed.
If remote's are being programmed for 2nd Car Operation press the # button on each of the 2nd car
remote's to be programmed.
Note: The park lights will flash once and the horn will honk once each time a new code is learned.
Note: Transmitter programming must done quickly. Do not pause more than one second between each transmitter.
All the transmitters to be used must be programmed at the same time. All transmitters not programmed
at this time will be erased from memory for security. The system holds a maximum of 4 transmitter
codes including 2nd car remote codes.
*If the Park Lights do not turn ON, turn ignition OFF, wait 5 seconds and repeat steps 1&2
Ignition 3x Press and
On/Off HOLD the
On/Off On Program
Button

Battery Replacement

The transmitter battery should be changed at least once every year to maintain
proper operating range. Replace with quality23A 12volt Alkaline battery.
Carefully remove
the screw from the
back of the remote.
Press the
Lock Button
Single Car Operation, Program
up to 4 remote's
Remove the top case
Then replace the
battery.
INSTALLATION MANUAL
Press the
Press the
# Button
Lock Button
Dual Car, Control 2 Ultra Start
vehicles with the same remote
Replace top case.
Re-install screw.
Page 21
Press the
# Button
Test remote for
proper operation.