Kingsman Marquis Infinite Series Installation Instructions Manual page 46

Back Liner, False
Bottom, and End Panel
Installation:
1. Remove Liner Clips from
the inside of the Firebox
(Fig.1).
2. Place the Back Liner onto
the firebox bottom with
bends facing the rear
firebox cover. Lift into
place and set down on
firebox ledge (See Fig.2).
3. Next install the False
Bottom with larger
Dimension to Front Glass
Opening (Fig.1), and
secure it using DT
screws into the mounting
tabs on the Burner Tube.
Insert Pilot Shield and
False Bottom Cover into
False Bottom.
4. Place End Panels on top
of the False Bottom and
tilt into place at either end
of the Firebox. Replace
the Liner Clips (Fig.1).
5. Place the bottom of the
door into the door
retainer slot, and then
secure the door with the
top latches (See Door
and Glass page in
manual if more
information is required).
6. To locate Valve Access
Cover, engage the tabs
into the slots in the
Access Panel Brackets
on the Fireplace.
⚠
Note: Warping and
Discoloration of Porcelain
or Painted Metal Liners Is
Not Covered Under
Warranty.
Both Porcelain and Painted
Metal Liners may discolor and
warp during normal operation
of your appliance. This is
normal, and not considered a
defect.
Fig.1
MQRB4436 / MQRB5143 Dimensions
Fig.2
Notched Side
on Bottom
Back Liner
1) Tilt into Firebox
Fig.3
Smaller Dimension
goes Behind
Burner Tube
MQRB6961 Dimensions
2) Lift into place and
Set on Firebox Ledge
3) Place onto Firebox
Bottom behind Burner
Tube
Pilot
46