Advertisement
S T E P
3
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 3B. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
3A. Attach Foam Roller Holders (E) to the Lower Upright (B) using:
2 - (#2) M10x70mm Hex Head Bolt
4 - (#4) M10 Flat Washer
2 - (#5) M10 Nylon Lock Nut
3B. Attach Hooks (E) to the Upper Upright (C) using:
2 - (#2) M10x70mm Hex Head Bolt
4 - (#4) M10 Flat Washer
2 - (#5) M10 Nylon Lock Nut
12
Advertisement
