Advertisement
S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 2C. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
2A. Attach Upper Upright (C) to Lower Upright (B) using:
3 - (#3) M10x25mm Hex Head Bolt
3 - (#4) M10 Flat Washer
2B. Attach Stability Ball Holder (F) to Lower Upright (B) using:
3 - (#3) M10x25mm Hex Head Bolt
3 - (#4) M10 Flat Washer
2C. Attach Stability Ball Holders (F) and Medicine Ball Holders to
the Lower & Upper Uprights (B & C) using:
12 - (#2) M10x70mm Hex Head Bolt
24 - (#4) M10 Flat Washer
12 - (#5) M10 Nylon Lock Nut
10
Advertisement
