5. Reference
. Reference
-1. Attaching an Arm
The stand can be removed and replaced with an arm (or another stand) to be attached to the monitor.
Note
• When attaching an arm or stand, follow the instructions of their user's manual.
• When using another manufacturer's arm or stand, confirm the following in advance and select one
conforming to the VESA standard.
- Hole spacing on the arm mounting: 100 mm x 100 mm
- Thickness of plate: 2.6 mm
- Strong enough to support weight of the monitor unit (except the stand) and attachments such as
cables.
• When using an arm or stand, attach it to meet the following tilt angles of the monitor.
- Up 45 degrees, down 45 degrees (horizontal display)
• Please connect cables after attaching an arm stand.
• Since the monitor and arm are so heavy, dropping them may result in injury or equipment damage.
Setup Procedure
1
Lay the LCD monitor on a soft cloth spread over on a stable surface with
the panel surface facing down.
2
Remove the stand. (Prepare a screwdriver.)
Unscrew the four screws securing the unit and the stand with the screwdriver.
3
Attach an arm stand to the LCD monitor securely.
Secure the monitor to the arm or stand using the screws specified in the user's manual of the
arm or stand.