Cabletron Systems 5000, 5500 Manual page 44

Attach Type
This button allows you to change the attachment type of the FDDI connection
to the device.
settings will not take effect until the concentrator is reset.
Table 3-1. Possible Attach Types
Other
DualAttach
SingleAttach
NullAttach
Insert Mode
This button allows you to select the mode for inserting M-ports into the
concentrator ring. Possible insertion modes are: Other (none of the following),
Standard, Scheduled, and Graceful.
Reset
This button allows you to initiate a reset of the control logic of all modules in
the device. The default is Other.
TrafÞc
Displays the value of the trafÞc meter, shown as a percentage of bandwidth
utilization on the network for the previous polling interval.
Enable Redirects
Allows you to select whether the device is able to send or receive ICMP
redirect messages.
Enable Modem
Allows you to select whether this deviceÕs RS-232 port modem control lines are
enabled or disabled.
Enable Rmon
Allows you to select whether this SNMP agent supports the RMON MIB.
9032208 E4
Table 3-1 shows the possible attachment types. New attach type
Attach Type
None of the following.
The Þrst FDDI port is conÞgured as an A port,
the second as a B port.
The Þrst FDDI port is conÞgured as an S port,
the second as an M port.
The Þrst two FDDI ports are conÞgured as M
ports.
Catalyst Stack System ConÞguration View
DeÞnition
ConÞguration Views
3-5