Download Print this page

Breville the Barista Pro BES878 Instruction Book page 14

Hide thumbs Also See for the Barista Pro BES878:

Advertisement

Available languages

Available languages

EXTRACTING ESPRESSO
• As a guide the espresso will start to flow after 8–10 seconds (infusion time) and should be the
consistency of dripping honey.
• If the espresso starts to flow after less than 6 seconds, you have either under dosed the filter
basket and /or the grind is too coarse. This is an UNDER EXTRACTED shot.
• If the espresso starts to drip but doesn't flow after 15 seconds, the grind is too fine. This is an
OVER EXTRACTED shot.
CORRECT EXTRACTION
• Flow starts after 8-12 secs
• Flow slow like warm honey
• Crema is golden brown with a fine
mousse texture
• Espresso is dark brown
AFTER EXTRACTION
REMOVE USED
GRINDS
Used grinds will form
a coffee 'puck'. If the
puck is wet, refer to
the 'Under Extraction'
section.
RINSE FILTER
BASKET
Keep the filter basket
clean to prevent
blockages. Without
LOCK TIGHT
ground coffee in the filter
basket, lock the
portafilter into the
machine and run hot
water through.
OVER EXTRATED
BITTER • ASTRINGENT
BALANCED
UNDER EXTRACTED
UNDERDEVELOPED • SOUR
14
UNDER EXTRACTION
• Flow starts after 1-7 secs
• Flow fast like water
• Crema is thin and pale
• Espresso is pale brown
• Tastes bitter/sharp, weak and watery
SOLUTIONS
INCREASE
GRIND AMOUNT
Adjust & re-test
Adjust & re-test
Tamp using 15-20kgs
of pressure. The top
edge of metal cap on the
tamper should be level
with the top of the filter
basket AFTER tamping.
Trim the puck to the
ALWAYS TAMP TO LINE
right level using the
Razor
precision dose
Adjust & re-test
trimming tool.
GRIND
GRIND DOSE
Too much
Too fine
Use razor to trim
8–10g (1 cup)
Optimum
19–22g (2 cup)
Too little
Too coarse
Increase dose & use razor to trim
OVER EXTRACTION
• Flow starts after 13 secs
• Flow drips or not at all
• Crema is dark and spotty
• Espresso is very dark brown
• Tastes bitter and burnt
SOLUTIONS
GRIND
DOUBLE
SEC
Adjust & re-test
Tamp using 15-20kgs
of pressure. The top
edge of metal cap on the
tamper should be level
with the top of the filter
basket AFTER tamping.
Trim the puck to the
ALWAYS TAMP TO LINE
right level using the
Razor
Adjust & re-test
trimming tool.
TAMP
Too heavy
15–20kg
Too light
GRIND
DOUBLE
SEC
DECREASE
GRIND AMOUNT
Adjust & re-test
precision dose

Hide quick links:

Advertisement

loading