Power In Connector - HP OMEN Maintenance And Service Manual

Power in connector

Description
For use only on products with 150 W AC adapter and NV N17P (GTX 1050/GTX 1050Ti) processors
For use only on products with 230 W adapter AC adapter GPU NV N17E (GTX1070/GTX1060) and AMD
R17M (RX580) processors
Before removing the power in connector, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Base enclosure (see
b. Battery (see
c. Speakers (see
d. Optical drive (see
e. Remove the fans (see
f. Remove the heatsink (see
g. Remove the system board (see
Remove the power in connector:
1. Remove the two Phillips screws securing the connector and bracket to the computer (1).
Base enclosure on page
Battery on page 37)
Speakers on page 46).
Optical drive on page
Fans on page 52)
Heat sink on page
System board on page
44)
47)
53)
56)
Component replacement procedures
Spare part number
926204-002
926564-001
59