Cabletron Systems SPECTRUM TRMMIM User Manual page 42

Using the TRMMIM Hub View
3. To activate the desired type of poll, click mouse button 1 on the selection box
4. To change a polling interval, highlight the value you would like to change, and
5. If you wish to use your new polling interval settings as the default values that
6. If you wish to replace existing values with the current set of default values, use
7. Click mouse button 1 on
You can set the update interval (in seconds) for the following:
Contact Status
Indicates the interval that the device waits between polling for the status of the
connection between SPMA and the device. This information appears in the form
of the contact status icon at the top right corner of the hub view.
2-26
Figure 2-13. TRMMIM Polling Intervals
to the right of each polling type field. Note that you will not be able to edit the
polling interval unless you have activated the polling.
enter a new value in seconds. Note that the Use Defaults option must not be
selected, or values will revert back to default levels when you click
and your changes will be ignored.
SPMA will use for each Token Ring Hub Module you are managing, use
mouse button 1 to select the Save as Defaults option. Note that these default
polling intervals will be applied to all intelligent Token Ring modules that you
are monitoring through SPMA.
mouse button 1 to select the Use Defaults option.
Changes take effect after the current polling cycle is complete.
once your changes are complete.
Managing the Hub at the Device Level
,