Mercedes-Benz E-Class Coupe 2022 Operator's Manual page 164

162 Driving and parking 162
R R eq equir uirements: ements:
The vehicle has been parked outside the
R
garage or outside the range of movement of
the door.
The vehicle is switched on.
R
The vehicle has not been started.
R
%
The garage door opener function is always
available when the vehicle is switched on.
Check if the transmitter frequency of the
#
remote control has the frequency range of
280 to 868 MHz.
Radio equipment approval number:
NZLMUAHL5 (USA)
R
4112A-MUAHL5 (Canada)
R
Press and hold button 1, 2 or
#
wish to program.
Indicator lamp 4 ashes yellow.
%
It can take up to 20 seconds before the indi-
cator lamp ashes yellow.
Release the previously pressed button.
#
Indicator lamp 4 continues to ash yellow.
Point remote control 6 from a distance of
#
0.4 in (1 cm) to 3 in (8 cm) towards button
1, 2 or 3.
Press and hold button 5 of remote control
#
6 until one of the following signals appears:
Indicator lamp 4 lights up green continu-
R
ously. Programming is complete.
Indicator lamp 4 ashes green. Program-
R
ming was successful. Additionally, syn-
chronization of the rolling code with the
door system must be carried out.
If indicator lamp
#
green: repeat the procedure.
Release all of the buttons.
#
%
The remote control for the door drive is not
included in the scope of delivery of the garage
3 that you
door opener.
Synchr hronizing t Sync onizing the r he rolling code olling code
R R eq equir uirements: ements:
The door system uses a rolling code.
R
The vehicle must be within range of the garage
R
door or door drive.
The vehicle as well as persons and objects are
R
located outside the range of movement of the
door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
4 does not light up or ash