Reese 19311 Use & Maintenance Instructions

WARNING:
Under no circumstances do we recommend exceeding the towing vehicle manufacturers recommended vehicles towing capacity.
Failure to follow instructions for installation and use may cause property damage, injury or death.
READ ALL INSTRUCTIONS BEFORE STARTING THE INSTALLATION OR USE
Figure 1

Gooseneck Ball Installation Instructions

1) Move handle to unlocked position shown in Figure 1, and insert Gooseneck ball into receiver opening.
2) Rotate handle to locked position as shown in Figure 2 & 3. Handle should drop below the top surface of
the gooseneck ball.
Note: If handle does not fully seat, the gooseneck ball is not fully engaged - DO NOT TOW.
Remove ball and inspect both ball and receiver for any damage, dirt or debris. If there is
damage DO NOT TOW. If there is any dirt/debris, clean as instructed below, then repeat
steps 1 & 2 above.

Gooseneck Ball Periodic Maintenance Instructions

The gooseneck ball should be stored when not in use. Periodically monitor the product for any
change in gooseneck ball handle pull force or ball bearing function.

Maintenance (Each Use):

1) Using a shop rag, remove any dirt, buildup, or debris from the gooseneck ball. Main locations
shown in Figure 4.
2) Using the gooseneck ball grease point shown in Figure 1,
spray White Lithium grease.
3) Remove from Hitch when not in use.
©
2018 Horizon Global America Inc.
Elite Pop-In Gooseneck Ball
Use & Maintenance Instructions
NOT FOR USE WITH GM FACTORY INSTALLED RAIL SYSTEMS
Grease
Points
Handle shall not protrude above
top surface when installed
Figure 2
Note: For any questions, please
- Scan QR code
- Visit www.reeseprod.com/qr-product.aspx
- Or call Technical Service at: 1-800-632-3290
Page 1 of 2
Part Number(s):
19311, 19314, 19315
Figure 3
(Side View)
Remove all
dirt & debris
19311N 11/26/18
Figure 4
Rev. B