DeWalt DW714 Original Instructions Manual page 22

EN G LISH
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
TROUBLE WHAT'S WRONG?
Saw will not start 1. Saw not plugged in
2. Fuse blown or circuit breaker tripped
. 3
4. Brushes worn out
Saw makes . 1
unsatisfactory cuts
2. Blade mounted backwards
3. Gum or pitch on blade
4. Incorrect blade for work being done
Blade does not come 1. Extension cord too light or too long
up to speed
2. Low house current
Machine vibrates 1. Saw not mounted securely to stand
excessively
2. Stand or bench on uneven floor
3. Damaged saw blade
Does not make accurate 1.
mitre cuts
2. Blade is not square to fence
3. Blade is not perpendicular to table
4. Workpiece moving
Material pinches blade 1. Cutting bowed material
20
Troubleshooting Guide
C o d r d a m a g e d
D l u b l a l d e
or work bench
Mitre scale not adjusted correctly
WHAT TO DO
1. Plug in saw.
2. Replace fuse or reset circuit breaker.
. 3 H a e v c o d r e r p a l e c d y b an authorised service agent.
4. Have brushes replaced by an authorised service agent
. 1 R e p a l e c b a l d . e R f e r e o t Mounting the Saw Blade.
2. Turn blade around. Refer to Mounting the Saw Blade.
3. Remove blade and clean with turpentine and coarse steel wool or household oven cleaner.
4. Change the blade type. Cutting wood use wood blade, cutting aluminum use aluminum blade.
1. Replace with adequate size cord.
2. Contact your electric company.
1. Tighten all mounting hardware. Refer to Bench Mounting.
2. Reposition on flat level surface.
3. Replace blade. Refer to Mounting the Saw Blade.
1. Check and adjust. Refer to Adjustments.
2. Check and adjust. Refer to Adjustments.
3. Check and adjust fence. Refer to under Adjustments.
4. Use vertical or level clamp to clamp workpiece securely.
1. Refer to Bowed Material under Special Cuts.
or replace them yourself. Refer to Brushes.