Operation; Layout For The Front Rear Panel - Matco Tools PCA68 Operator's Manual

4.1 Layout of Front and Rear Panel
1 Power Pilot Lamp
2 Alarm Pilot Lamp
3 Air Indicator
4 Ready (DC Indicator)
Cutting Current
5 Regulator
6 RUN/SET
7 Cutting Gun Connector
8 CNC Connection
9 Positive Output Cable
10 Barometer
11 Mains Cable
12 Power Switch
13 Fan

4 Operation

This will light if the machine is connected to power
When lit, this light indicates that the alarm on the machine is active
The AIR light will turn on if there is insufficient gas pressure(Below 50 Psi)
Indicator is ON when DC output is active
Regulates the current when cutting
when cutting the work piece, turn to the "RUN" setting; when doing a gas test, turn to
"SET"
Connects gun to machine
Connection for CNC plug
Connect to work piece
Ensures that there is no impurity and/or moisture in the compressed air
Connected to power supply
Turn on or off the power source.
Help plant cooling
5