Husqvarna R112C Workshop Manual page 23

9.1.3.2 To adjust the parking brake cable (R112C5)
WARNING: An incorrectly adjusted brake can
cause decreased brake capacity.
1. Make sure that the brake lever (A) is vertical. If the
parking brake lever is not vertical, adjust the brake
as follows.
D
2. Pull the rubber sleeve (B) rearward.
3. Loosen the locknut (C).
4. Adjust the nut (D) to until the brake lever (A) is
vertical.
5. Tighten the locknut (C).
6. Pull the rubber sleeve (B) forward.
7. If the parking brake does not apply after the
adjustment, adjust the parking brake with the screw
(E).
9.1.3.3 To replace the parking brake cable
1. Loosen the spring at the front end of the parking
brake cable.
2. For R112C5:
1342 - 002 -
C B
E
a) Remove the spring (A) at the rear end of the
parking brake cable.
b) Remove the brake cable from the brake arm (B).
3. For R115C:
A
a) Loosen the locknuts (A).
C
b) Remove the parking brake cable from the
bracket (B).
c) Remove the parking brake cable from the brake
arm (C).
4. Install in the opposite sequence.
5. Do a check of the parking brake cable and adjust if it
is necessary. Refer to
cable (R112C5) on page 23 .
9.1.4 Wheel hub
9.1.4.1 To remove and install the wheels
CAUTION: The dimension of the spacers and
the number of washers can change between
different wheels. Do not mix parts from different
wheels.
1. Put supports below the product. Refer to
supports below the product on page 6 .
2. Remove the protective cap.
A
B
A
B
To adjust the parking brake
To put
Repair instructions - 23