Mitsubishi Electric FR-F862 Instruction Manual page 10

1.2
Inverter component names
Component names are as follows.
(a)
(d)
(b)
(c)
(e)
(f)
(k)
(n)
Symbol Name
(a) RS-485 terminals
(b) Plug-in option connector 1
(c) Plug-in option connector 2
(d) Plug-in option connector 3
(e) Voltage/current input switch
(f) Control circuit terminal block
(g) PU connector
(h) USB A connector
(i) USB mini B connector
(j) Front cover (upper side)
(k) Power lamp
(l) Alarm lamp
(m) Charge lamp
(n) Accessory cover
(o) Front cover (lower side)
(p) Main circuit terminal block
(q) Cooling fan
Switches for manufacturer
(r)
setting (SW3 and SW4)

Refer to the Instruction Manual (Detailed) of the FR-F860.
(g)
(h)
(i)
(r)
(j)
(m)
(o)
(l)
Enables RS-485 and MODBUS RTU, and BACnet communication.
Connects a plug-in option or a communication option.
Selects between voltage and current for the input via terminals 2 and 4.
Connects cables for the control circuit.
Connects the operation panel or the parameter unit. This connector also
enables the RS-485 communication.
Connects a USB memory device.
Connects a personal computer and enables communication with FR
Configurator2.
Needs to be removed for control circuit wiring, installation of a plug-in
(communication) option, RS-485 terminal wiring, changing of the voltage/
current input switch setting, etc.
Stays ON while the power is supplied to the control circuit (R1/L11, S1/L21).
Turns ON when the protective function of the inverter is activated.
Stays ON while the power is supplied to the main circuit.
Remove this cover for using the PU connector.
Remove this cover for wiring.
Connects cables for the main circuit.
Cools the inverter.
Do not change the initial setting (OFF
Inverter component names
Description
).
OFF
ON
INTRODUCTION
(q)
(p)
Refer to
page
46
1
Instruction
Manual of
the option

32
44
45
45
15
28
59
28

15
27
68
─
9