Mitsubishi Electric FR-F862 Instruction Manual page 37

Table of Contents

Advertisement

Control circuit
Output signal
Terminal
Terminal name
symbol
A1,
Relay output 1 (fault
B1,
output)
C1
88R,
For manufacturer setting. Do not use.
88S
Inverter operation
RDA
enable (NO contact)
Inverter operation
RDB
enable (NC contact)
RSO
Inverter reset
Instantaneous power
IPF
failure
FAN
Cooling fan fault
Open collector output
SE
common
CAUTION
 Do not use the empty terminals (NCs) of the control circuit. Doing so may lead to damage of the converter unit
and the inverter.
 Always connect between terminal RDA of the converter unit and terminal MRS (X10) of the inverter, and between
terminal SE of the converter unit and terminal SD (terminal PC in the source logic) of the inverter. Failure to do
so may lead to damage of the converter unit.
2.6.3
Control logic (sink/source) change
Switch the control logic of input signals as necessary.
To change the control logic, change the jumper connector position on the control circuit board.
Connect the jumper connector to the connector pin of the desired control logic.
The control logic of input signals is initially set to the sink logic (SINK).
(The output signals may be used in either the sink or source logic independently of the jumper connector position.)
NOTE
• Make sure that the jumper connector is installed correctly.
• Never change the control logic while power is ON.
36
INSTALLATION AND WIRING
Terminal function description
1 changeover contact output that indicates that the protective function of
the converter unit has been activated and the outputs are stopped.
Fault: discontinuity across B and C (continuity across A and C), Normal:
continuity across Band C (discontinuity across A and C)
The output is in LOW state when the converter unit operation is ready.
Assign the signal to terminal MRS (X10) of the inverter.
The inverter can be started when the RDA status is LOW.
The output is in LOW state when a converter unit fault occurs or the
converter is reset.
The inverter can be started when the RDB status is HIGH.
The output is in LOW state when the converter is reset (RES-ON).
Assign the signal to the terminal RES of the inverter.
The inverter is reset when it is connected with the RSO status LOW.
The output is in LOW state when an instantaneous power failure is
detected.
The output is in LOW state when a cooling fan fault occurs.
Common terminal for terminals RDA, RDB, RSO, IPF, FAN
Connect this terminal to the terminal SD (sink logic) or PC (source logic)
of the inverter.
Jumper connector
Jumper connector
Jumper connector
SOURCE
SINK
For sink logic
Rated
specification
Contact capacity: 230
VAC 0.3 A (power
factor = 0.4)
30 VDC 0.3 A
Permissible load:
24 VDC (27 VDC at
maximum) 0.1 A
(The voltage drop is
2.8 V at maximum
while the signal is
ON.)
The open collector
transistor is ON
(conductive) in LOW
state.
The transistor is OFF
(not conductive) in
HIGH state.
———

Advertisement

Table of Contents
loading

This manual is also suitable for:

800 seriesF800

Table of Contents